What is the margin of safety for a router table?

Maintain a 4” inch margin of safety when using the fence or miter gauge, and a 6” inch margin of safety when using depth collars. If the part is too small to allow this margin, design and build a special holder or push board.

What are the safety tips of using wood shaper?

What safety procedures should you follow when using shapers?

1. Wear safety glasses with side shields or safety goggles, or a face shield (with safety glasses or goggles).
2. Wear hearing protection that is suitable for the level and frequency of the noise you are exposed to in the woodworking area.

What are the safety precautions in operating the shaper machine?

What should be avoided?

• Do not remove cuttings or reach across the table while the ram is moving.
• Do not adjust the machine while it is operating.
• Do not use bolts or nuts with stripped threads to hold down work clamps.
• Do not leave a shaper running unattended.
• Do not use bare hands or compressed air to remove cuttings.

What is the margin of safety on a drill press and router?

If not using the router table, hold the router firmly, when turning on the power, to overcome the starting torque of the motor. 8. Maintain a MINIMUM 2” margin of safety. Keep awareness of your fingertips and their proximity to the bit even after power is turned off until the bit comes to a complete stop.

What are the safety precautions followed in the wood workshop?

In order to ensure total safety culture, commit to these seven rules and experience a much safer and more enjoyable woodworking hobby:

1. Gear Up.
2. Stay Alert and Focused.
3. Always Remember to Disconnect.
4. Declutter.
5. Avoid Using Dull Tools.
6. Handle Tools Properly.
7. Keep Distractions Away.

What are the safety rules to be followed while working on mechanical machine tools explain by taking example of any machine tool?

Machine Maintenance

• Do not attempt to oil, clean, adjust or repair any machine while it is running.
• Ensure that all machine guarding is in place and functioning properly.
• Do not leave machines running unattended.
• Do not try to stop the machine with your hands or body.
• Always keep hands, hair, feet, etc.

What are the specifications of a shaper?

Specification of Shaper Machine:

• The maximum length of stroke ram.
• Types of the drive ( Crank, Gear and Hydraulic type)
• Power input of the machine.
• Floor space required to establish the machine.
• Weight of the machine in tonne.
• Feed.
• Cutting to return stroke ratio.
• Angular movement of the table.

What should you not do on a router table?

Don’t trap the stock. When shaping an edge on the router table, always rout with the bit inside the fence and the material edge against the fence—never rout the far edge, which traps the stock between the bit and the fence. This can cause the bit to catch the wood and hurl it suddenly.

Does a drill press require a guard?

This standard does apply to drill presses and lathes, and it is the Occupational Safety and Health Administration’s (OSHA) policy to require protection for employees by guarding methods such as barrier guards.

What are the safety precautions when using a drill press?

Safety Rules Safety glasses are required. Don’t wear loose clothing or gloves, keep long hair tied back. These items will get caught in bit or spindle. Never adjust the drill press or setup while it is running.

What are the main parts of shaper?

Shaper Parts:

• Base: The base of the machine is the main body of the machine and serves as the backbone for the other parts.
• Column: The Column of a shaper machine is a cast-like casting that is cast from iron and mounted on a pedestal.
• The cross-rail:
• Workbench Table:
• Ram:
• Tool Head: