What is route map in Cisco ASA?

What is route map in Cisco ASA?

Route maps are used when redistributing routes into an OSPF, RIP, EIGRP or BGP routing process. They are also used when generating a default route into an OSPF routing process. A route map defines which of the routes from the specified routing protocol are allowed to be redistributed into the target routing process.

How do I create a route map on my Cisco router?

Here are some examples of set commands:

  1. Change the BGP AS path length.
  2. Set a BGP community.
  3. Set the BGP weight.
  4. Set the metric of an OSPF or EIGRP route in redistribution.
  5. Set a redistribution tag.
  6. Set the next hop IP address in policy-based routing.
  7. Set the DSCP value of an IP packet.
  8. And many other options…

Can Cisco ASA do routing?

Routing Support on ASA Cisco ASA firewalls support both static and dynamic routing.

What is route map command?

What is ASA Router?

In brief, Cisco ASA is a security device that combines firewall, antivirus, intrusion prevention, and virtual private network (VPN) capabilities.

What is the purpose of route map?

A route map defines which of the routes from the specified routing protocol are allowed to be redistributed into the target routing process. of ACL or route maps consists of a list scan, in a predetermined order, and an evaluation of the criteria of each statement that matches.

What is ip policy route map?

Policy-based routing is a process whereby the device puts packets through a route map before routing them. The route map determines which packets are routed to which device next. You might enable policy-based routing if you want certain packets to be routed some way other than the obvious shortest path.

How do I use a route map?

How do I add a route to ASDM?

Adding a default route is very similar to adding a static route on the ASDM. Once again, navigate to Configuration | Device Setup | Routing | Static Routes on the ASDM. Click on Add….Adding a default route using the ASDM

  1. Interface: Outside.
  2. Network: any.
  3. Gateway IP: Your ISP gateway IP address (verify with your ISP):

How does Cisco route map work?

How do I configure Policy Routing?

Configuring a policy route

  1. Go to Network > Policy Routes.
  2. Click Create New > Policy Route.
  3. Configure the following fields: Incoming interface. port1. Source Address. 0.0.0.0/0.0.0.0. Destination Address. 0.0.0.0/0.0.0.0. Protocol. TCP. Destination ports. 21 – 21. Type of service. 0x00. Bit Mask. 0x00. Outgoing interface.
  4. Click OK.