Can you change DSC 1616 1832 or 1864 Delay times?

Can you change DSC 1616 1832 or 1864 Delay times?

How do I change DSC 1616, 1832, or 1864 delay times?

1. Press *8-installer code to go into programming.
2. Enter 005.
3. The system will then want a two digit partition number.
4. First, enter the 3 digit entry delay 1 in seconds.
5. Then, the 3 digit entry delay 2 in seconds.
6. Finally, the 3 digit exit delay in seconds.

How do you reprogram an alarm system?

You can reset your alarm system by powering it down and then powering it back on. This is what is known as a power reset. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. Then reconnect the battery and transformer to power it back on.

How do I reset my DSC alarm?

Steps to Reset Your DSC Home Alarm

1. Open the access door on your keypad.
2. If your keypad is beeping, press # to silence it.
3. Enter your master code twice, back-to-back.
4. Press and hold the Reset button for three seconds. Or, press * and 72 if your keypad doesn’t have the Reset button.

What is the user manual for the pc1616/pc1832/pc 1864?

PC1616/PC1832/PC1864 User Manual WARNING: This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read.

What power supply do I need for a DSc PTD 1640u?

Primary: 120VAC/ 60Hz./0.33A Secondary: 16.5VAC/40VA DSC PTD 1640U Plug-in, Class 2 Transformer. Use DSC PTD 1640U

What is the warranty on a DSc product?

LIMITED WARRANTY (a) NO WARRANTY – DSC PROVIDES THE SOFTWARE “AS IS” WITHOUT WARRANTY. DSC DOES NOT WARRANT THAT THE SOFTWARE WILL MEET YOUR REQUIREMENTS OR THAT OPERATION OF THE SOFTWARE WILL BE UNINTERRUPTED OR ERROR-FREE.

What are the special Installer functions of powerseries-pc1616/pc1832/pc 1864 46?

PowerSeries – PC1616/PC1832/PC1864 46 Special Installer Functions [900] Panel Version Displayed [901] InstallerWalk Test Mode Enable/Disable [902] Module Supervision Reset [903] Module Supervision Field [904] Wireless Module Placement Test [905] – [909] For Future Use [990] Installer Lockout Enable [991] Installer Lockout Disable