How do I disable Cobra Immobiliser?
The 8510 immobiliser auto arms 60 seconds after the ignition is turned off. To disarm it simply press a coded touch key to the receiver and the LED will stop flashing.
How do I program my Cobra Immobiliser?
Immobiliser Programming instructions
- Turn the ignition ON and OFF 3 times, then ON within 7 seconds.
- The LED will illuminate permanently.
- Touch a working touch key onto the receptacle, the LED will extinguish for 1 second.
- Repeat step 3 for the additional keys you want to add.
- Switch the ignition OFF to exit programming.
How do I reset my Cobra immobilizer?
Press the largest button on one of the key fobs until the alarm LED turns off. It will flash back on if more than one remote is being programmed. Press the largest button on the remaining key fobs, one by one, until the alarm LED remains off.
How do I reprogram my Cobra alarm remote?
Registered. hold the new fob close to the car (within 1 metre) and press and hold both buttons down (small LED should start to flash between the two) for 10 secs – LED should then stay on – release both and then immediately press the larger one and hold for one sec – then release.
How do you reset car alarm fob?
Try inserting your key into the door lock and turning the key to the locked position and then turning the key into the unlock position twice. This may temporarily disable the vehicle’s alarm while you drive. Step 4: Hold key in unlock position. You can also try holding the key in the unlock position for two seconds.
How do you reprogram a cobra key fob?
How do I reset my car remote?
Press and hold the “lock” button on your car remote for one second, then put the key into the ignition, and turn it on. The lights should be turned off if the key is turned to “Off”.
How do I calibrate my car alarm?
The sensitivity of a car alarm is usually set on the shock sensor, which is going to be a small box that’s about three square inches underneath the dashboard on the driver’s side. You can adjust this shock sensor by moving the adjustment dial. Turning it counter clockwise will turn it down.
How do I adjust my car alarm volume?
- Switch the ignition ON (engine off or on).
- Select [Settings] on the center display.
- Select [Vehicle] on the center display.
- Select [Door Lock] on the center display.
- Select Keyless Lock Beep Volume.
- Select one of: High / Medium / Low / OFF.
Will disconnecting battery reset car alarm?
Car alarms rely on the electronic component of the vehicle, and disconnecting the battery should both silence the siren and reset your alarm. Open up the hood, locate the battery, and with a wrench, remove the negative terminal. Then reconnect it after a minute has passed.
Is the Cobra 8510 right for You?
If you need a no nonsense immobiliser that’s been trusted by trade experts for over 20 years the Cobra 8510 is for you. Perhaps your insurance company has asked you to bring your classic car up to Thatcham category 2 status and you want to do this with the market leading immobiliser. If that’s the case then the Cobra 8510 is for you.
How do you use a Cobra a8510 immobiliser?
✔ Cobra’s A8510 is known the world over as the most reliable touch key immobiliser ever. ✔ Simple to use. Just Touch the key onto the receptacle and away you go. ✔ The immobiliser is armed once the ignition has been turned off for more than 30 seconds. To choose the installation option just click on the drop-down menu and select your area.
How do I disarm the 8510 immobiliser?
The 8510 immobiliser auto arms 60 seconds after the ignition is turned off. To disarm it simply press a coded touch key to the receiver and the LED will stop… AboutPressCopyrightContact usCreatorsAdvertiseDevelopersTermsPrivacyPolicy & SafetyHow YouTube worksTest new features