How do you program a key fob for a 2008 Dodge Charger?

INSERT the new FOBIK remote key into the Ignition and TURN it to the ON/RUN position. After 10 seconds, the Immobilizer Warning Lamp will FLASH to indicate successful programming of this FOBIK remote key. TURN Ignition to OFF/LOCK and REMOVE FOBIK to Finalize programming of the remote and EXIT Programming Mode.

How do you start a 2008 Dodge Charger without the key fob?

Once inside the vehicle put they key fob near the power start stop engine button on Your vehicle. It will still be able to sense it even though it’s dead. Now press down the on brake pedal and press the start engine button like You normally would. There is no way to start a Dodge Charger without a key fob.

How much does a Dodge Charger key cost?

Compare with similar items

	This item Mopar OEM Dodge Keyless Entry Remote Fob 4-Button Smart Proximity Key (FCC ID: M3N-40821302/P/N: 68051387)	KeylessOption Keyless Entry Remote Car Smart Key Fob Starter for Dodge Dart Charger Challenger M3N-40821302
Price	$4990	$3495
Sold By	OE PARTS	KeylessOption

Can you start a Dodge Charger with the key?

You can still start your Dodge vehicle: Locate the analog key hidden inside the key fob. To do this, flip the fob over, slide the switch at the top left, and pull out the silver key.

How do you program a Dodge Charger key fob?

After inserting the key into the ignition, turn it to the “RUN” position while pressing and holding down the “UNLOCK” button on the driver’s door. Simultaneously hold down the “UNLOCK” button and the “PANIC” button, then release them at the same time.

Does dealer have to reprogram a key fob?

Dealerships, car shops, and auto locksmiths should all have access to the machines needed to reprogram key fobs, going above and beyond the normal steps you would take to do it yourself. So you may be charged a bit for the use of their machine. You don’t necessarily have to take your car into the shop to have this done.

How to change the battery in the key fob?

Find the notch to open the fob. This is the trickiest part because the notch may not be obvious.

Use the screwdriver to pop it open. Slide the flat-tipped screwdriver into the slot and wedge it open.

Identify the battery type.

Replace the old battery with a new one.

Snap the fob shut.

How do you change the battery in the key fob?

Pry the battery out with a screwdriver. The battery looks like a small,silver coin placed in fob’s center.

Slide the new battery into place. Fit the new battery into the slot where the old one was.

Screw the fob back together. Put the cover back on the fob.

Test the key fob. Point the key fob at your car or other device and attempt to use it.