How do you read Ford casting numbers?

How do you read Ford casting numbers?

In order, here is what each digit in a Ford part or casting number represents:

1. DIGIT #1—DECADE OF MANUFACTURE: A – 1940.
2. DIGIT #2—YEAR OF THE DECADE:
3. DIGIT #3—CAR LINE:
4. DIGIT #4—ENGINEERING OFFICE RESPONSIBLE FOR ORIGINAL DESIGN:
5. DIGITS #5-9—BASIC PART NUMBER:
6. DIGITS #10-12 (SUFFIX)—DESIGN CHANGE:
7. TYPICAL DATE CODE:
8. 9A21.

How do I know what Ford engine I have?

Locate the ID tag under coil attaching bolts for six-cylinder and some eight-cylinder engines. The tag is a series of numbers and letters etched in and used to decipher the year, make, and model of you engine. It is found underneath the bolts on the left or right side of the engine, near the front of the car.

Where are the casting numbers on a Ford block?

Illuminate the section of the block where Ford stamped the casting number. This is directly beside the starter mount, where the starter motor bolts to the engine. Write down the casting number down with pen and paper.

How do I identify a big block Ford engine?

Ford’s part number convention generally follows the format of a four digit casting code, followed by a four digit basic part number, which will be “6015” for an engine block, followed by the revision version.

How do you tell a 429 from a 460?

Both the Ford 429- and 460-cubic-inch engines, members of the 385 family, fall into this category. Both came with the same block, so the only methods of positive identification involve locating the ID tag, measuring the stroke or verifying the crankshaft number.

Where is the casting number on a 302?

Locate the casting numbers on your engine block by checking above the starter on the right hand side of the block.

Are there any aftermarket engine blocks for Ford V8 engines?

While the aftermarket has done an exceptional job of creating performance engine blocks for Ford’s line of V8 engines, sometimes you aren’t looking for an aftermarket engine block. Whether it’s for a correct restoration, or a budget build, sometimes an original FoMoCo engine block is what you’re looking for.

What is the part number on a Ford engine block?

Numbering Convention Ford’s part number convention generally follows the format of a four digit casting code, followed by a four digit basic part number, which will be “6015” for an engine block, followed by the revision version.

What is a Ford FE medium block?

FE medium block: Derived from the “Ford-Edsel” name, the FE is bigger than a small-block, but smaller than a big-block, earning it the moniker of a “medium-block.”

When did the Ford 335 small block come out?

Cleveland small-block: The Ford 335 small-block family introduced in 1969, was referred to as the “Cleveland” engine, due to the fact that they were built in the Cleveland engine plant. They came in 351 cubic-inch and 400 cubic-inch variants, and were known for their large port and valve sizes, and remained in production until 1982.