What do you do when your bathtub and toilet is clogged?

What do you do when your bathtub and toilet is clogged?

Close the tub drain or have a helper block it while you plunge the toilet. Blocking the tub drain will direct more pressure toward the obstruction. Clear the blockage with a toilet auger if plunging has no effect. Insert the head of the auger into the toilet bowl and push until you encounter resistance.

What does it mean when you flush the toilet and the bathtub gurgles?

When the toilet is flushed, the rush of water into the sewer is pulling air through the tub drain causing the gurgling noise. In cold weather, simply run hot water to the sinks and look outside to see if steam is coming out of the roof vent pipes. In an attic, make sure the vents are not blocked or covered.

How do you unclog a sewer line?

How to clear a main sewer line clog

1. Step 1: Loosen the cap on the drain pipe. Loosen the cap on the drain pipe.
2. Step 3: Feed the auger cable into the drain pipe.
3. Step 4: Run the auger until the clog is clear—and beyond.
4. Step 5: Hose down the pipe and auger cable.
5. Step 6: Slowly pull the auger back out of the pipe.

Can a gurgling toilet fix itself?

Bad news/good news: If your toilet is gurgling due to a water main problem, there’s no way you can fix it yourself. However, it may be your town’s responsibility, not yours. The physics here are the same: There’s a blockage in the pipe. Negative pressure forces air to return through the channel from where it came.

How do I unblock my main sewer line?

What is the best product for a clogged toilet?

Making a Drain Cleaner Heat half a gallon of water. If the toilet tends to clog easily as the result of trying to flush too much waste, using a combination of hot water, baking soda and vinegar will often do the job as well as a commercial drain cleaner. Pour 1 cup baking soda and 2 cups vinegar into the toilet.

What to do when a toilet is clogged?

Flush the toilet to check the drainage. If the plunging eventually drains the bowl, but the clog is still blocking a free flow down the drain, leave the plunger in the bowl and fill the bowl with water again. Fill it to the point it is normally after a regular flush, then plunge again.

How to fix a clogged toilet?

Wait about 10-15 minutes before trying to unclog the toilet,as some water might drain on its own.

Squeeze a lot of liquid dish soap,about one cup,or pieces of bar soap into the toilet bowl.

Fill a bucket with hot water and carefully pour hot water into the toilet bowl without overflowing it.

Wait another 15 minutes for the soap to dislodge the clog.

The water level will go down after 15 minutes,so pour more hot water into the bowl to restart the lubrication process.

After another 15 minutes of waiting,you can flush the toilet and the clog will be gone!

Why does my toilet get clogged often?

Most toilets clog at one time or another. Common causes include low water pressure that fails to move material with enough force, and attempts to flush too much at once. Whereas stopped stink drains can often be remedied with an additive that breaks up the clog, such products are usually inappropriate for toilet clogs.