What does exhaust gas recirculation control circuit range performance mean?

What does exhaust gas recirculation control circuit range performance mean?

It is a generic OBD trouble code that activates if the powertrain control module (PCM) detects erratic Exhaust Gas Recirculation (EGR) valve performance. It could mean that your EGR valve isn’t doing what it’s supposed to do in specified parameters such as being fully open when it should only be partially open.

What does P0405 code mean?

Diagnostic trouble code (DTC) P0405 stands for “Exhaust Gas Recirculation Sensor A Circuit Low.” It denotes that the readings coming from the EGR valve position sensor show lower voltage levels than normal. If the signal from the sensor appears strangely low, the PCM may set a P0405 code.

How do I fix code P0403?

What repairs can fix the P0403 code?

  1. Replacing the shorted or open EGR vacuum solenoid.
  2. Replacing a corroded connector to the EGR vacuum control solenoid.
  3. Repairing the wiring shorted to the EGR vacuum control solenoid.

What are the symptoms of a bad EGR sensor?

EGR valve symptoms can vary, however, the most common symptoms of a faulty EGR valve are explored below:

  • Your engine has a rough idle.
  • Your car has poor performance.
  • You have increased fuel consumption.
  • Your car frequently stalls when idling.
  • You can smell fuel.
  • Your engine management light stays on.

What does p0488 code mean?

What Does Code P0488 Mean? A stored code P0488 means that the powertrain control module (PCM) has detected a discrepancy between the actual position of the exhaust gas recirculation (EGR) valve and the desired throttle position.

How to test a p0488 EGR throttle control valve?

If the P0488 code does return, we will need to test the EGR throttle control valve and its associated circuits. Typically, there are either 3 or 4 wires at the EGR throttle control valve. Disconnect the harness going to the EGR throttle control valve.

What does code p0488 mean on the Avensis T27?

Our Avensis T27 2010 is showing all the lights on the dash. AutoDoktor OBD2 is showing only code P0488. (EGR Throttle position circuit) After replacing of the EGR unit the same error appears.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top