What color is the wire for the ignition?

What color is the wire for the ignition?

Red, Black, White-Red and White Black are the new colors of the key ignition switch wiring.

What year did dodge start using electronic ignition?

1972
The Mopar electronic ignition system introduced in 1972 was cutting edge in its day. While everyone else was using the ancient points-type ignitions, Chrysler scooped ’em all with the electronic unit.

What wire goes to the ignition switch?

The vehicle’s ignition wire goes to the “IGN” terminal of the ignition switch. This is an essential terminal because it serves the vehicle ignition, wipers, accessories, and other operating features. It is also the normal “run” position of the switch.

What is a ballast resistor for a ignition coil?

A Ballast Resistor is an electrical device that reduces voltage to the coil so that more energy is available for the spark plugs during starting.

How do you install an electronic ignition module?

How to… fit electronic ignition to your classic car

1. 1: UNCLIP DISTRIBUTOR CAP.
2. 2: REMOVE CONDENSER/POINTS.
3. 3: SCREW IN MOUNTING PLATE.
4. 4: INSTALL IGNITION MODULE.
5. 5: PRESS TRIGGER DISC ON.
6. 6: EXTEND WIRING IF NEEDED.
7. 7: REPLACE THE OLD COIL.
8. 8: FIT BALLAST RESISTOR/COIL.

What was the first car to have electronic ignition?

The 1912 model Cadillac became the first car to replace the hand crank with an electric starter motor. Most automobile manufacturers switched over to the electric starter during the teens, although Ford’s Model T continued using the hand crank through 1919.

When did electronic ignition replace points?

1970s
Fortunately, there is something you can do about it. When points were superseded by electronic (also called “breakerless”) ignition in the mid-1970s, a star wheel and pickup replaced the points in the distributor sent a reluctance signal to an electronic box that was mounted on the firewall.

What is the electronic ignition system on a Dodge Ram?

Dodge Electronic Ignition This system consists of a special pulse-sending distributor, an electronic control unit, a two-element ballast resistor, and a special ignition coil. The distributor does not contain breaker points or a condenser, these parts being replaced by a distributor re­luctor and a pick-up unit.

How do I install the Mopar electronic ignition?

Installing the Mopar electronic ignition requires a distributor with the magnetic pickup, and one more wire to the ballast resistor. This wiring diagram is for the 1980 and later four pin ignition module.

What are the effects of electronic ignition on a Dodge Charger?

This degradation can cause a narrowing point gap, retarded timing, increased dwell, and, eventually, a very poor-quality spark. Above: Our 1970 Dodge Charger R/T packing its original 440 still. One major benefit of electronic ignition is that its non-contact within the distributor.

When did electronic ignition start in cars?

Unfortunately, that was some fifty years ago and points have now become prehistoric. Chrysler debuted the electronic ignition system in 1972 and didn’t looked back. In the twenty years after its inception, electronic ignition made its way on to millions of Mopar products.