How do I reconfigure my Linksys router?

How do I reconfigure my Linksys router?

Locate the Reset button and, using a pen or a paper clip, press and hold the Reset button for 10 seconds. QUICK TIP: For router models such as the Linksys Wireless-B and Wireless-G routers, press and hold the Reset button for 30 seconds. QUICK TIP: Observe the Power light of the router while pressing the button.

How do I change my Linksys e4200 router name and password?

Changing the router’s wireless network name and password using Linksys Connect

1. Launch Linksys Connect.
2. On the main Linksys Connect window, select Router settings then click Change.
3. Under the Personalize section, click Change to modify your router’s name and password.

How do you refresh a router?

Steps to Reboot a Router and Modem

1. Unplug the router and the modem.
2. Wait at least 30 seconds.
3. Plug in the modem.
4. Wait at least 60 seconds.
5. Plug in the router.
6. Wait at least 2 minutes.
7. When the router and modem restart, test to see if the problem went away.

How do I reset my Linksys E2500 router?

There are two (2) ways in resetting the Linksys E2500 to factory defaults:

1. Press and hold the Reset button at the bottom of your router for 10 seconds then release.
2. Log in to the router’s web-based setup page then go to Administration > Factory Defaults > Restore Factory Defaults.

How do I access my Linksys E2500 router settings?

For the Linksys E2500, you have to do the following steps for access:

1. Put router into operation.
2. Connect the device via Wi-Fi* or a network cable with the router.
3. Open web browser.
4. Insert IP address in the address bar and confirm with ‘Enter’ button.
5. Enter username and password in the open user interface and confirm again.

What is Linksys WRT160N used for?

HARDWARE INFORMATION. The Linksys WRT160N Wireless-N Broadband Router is a three-in-one device. It acts as a wireless access point which lets you connect your wireless computers and devices to it without using wires. It also serves as a built-in 4-port full-duplex 10/100 switch to connect your wired devices to it using Ethernet cables.

What default IP address is used to login to WRT160N?

What default IP Address, username and password are used to login to the Linksys WRT160N web-based setup page? The default IP Address of a Linksys router is 192.168.1.1. Leave the username blank and then the password is “admin”. 3.

How to configure a wireless router?

Here are some steps to help you configure it. Connect to the router. Use an ethernet cable, and plug your computer into the router. Then turn on the router and connect to it using a web browser such as Internet Explorer or Firefox. This is done by typing the IP address of the router.

How do I restrict access to my wireless router?

Steps Connect to the router. Enter your information. Basic setup. Continue to the Wireless tab. Click the Wireless Security link. Select “Access Restrictions.”. Use the Applications and Gaming tab. Set a router password on the Administration tab. Click the Status tab to verify connectivity and router status.