Is it better to drill into tile or grout?

Is it better to drill into tile or grout?

Grout isn’t as stable and strong as tile, and drilling into grout isn’t recommended.

How far out should curved shower rod be?

The midpoint of the rod should extend several inches past the outside rim of the tub. Depending upon tub model, mount rod between 6″ and 8″ from center line of the tub. The middle portion of the rod should curve just outside the contour of the tub.

How do you drill through porcelain tile without cracking it?

Steps for Drilling Through Porcelain Tile

1. Make a mark. Apply masking tape to the tile and mark the spot you wish to drill.
2. Start slowly. Using the variable speed on your drill, start at the slowest setting.
3. Cool off the drill bit. Every 15-30 seconds, dip your drill bit in cutting oil or spray it with cold water.
4. Repeat.

How do you install a curved shower rod?

Install Mounting Brackets: Once the plastic wall anchors are in place, fasten the new curved shower rod brackets to the wall using the new screws provided with your shower rod kit. Install curved shower rod: Clip one end of the curved shower rod into the bracket as instructed by the manufacturer’s instructions.

What is the height to install a curved shower rod?

Method 1 of 2: Adhering to General Rules Select a rod that matches the rest of your bathroom fixtures. Position the shower rod high enough that you won’t bump your head. Place the shower rod at least 74 inches (188 cm) above the shower floor. Cut your rod if necessary.

How do you install tension shower rod?

Installing your shower rod. – To install a tension shower rod, you need to twist the rod clockwise to elongate it. – Put one end of the rod on the right side of the shower wall and the other end on the left, then slowly twist the rod clockwise to apply tension.

How do you install curtain rod brackets?

Place the rod into the right-side bracket and use a level to determine the placement of the left side bracket. Align the bracket over the center of the 1-1/2” mark you made earlier. Use a pencil to mark the holes where the screws will go. Remove the rod, and repeat steps 4 to secure the left-side bracket to the frame.