How do I print a network configuration page on a Brother HL 5450DN?

How do I print a network configuration page on a Brother HL 5450DN?

Using the control panel button:

1. Make sure that the front cover is closed and the power cord is plugged in.
2. Turn on the machine and wait until the machine is in the Ready mode.
3. Press Go three times within 2 seconds. The machine will print the current printer settings page.

How do I print a test page on a Brother HL 5450DN?

NOTE: The screens may differ depending on operating system being used and your Brother machine.

1. Open Printer Properties. (Click here to see how to open Printer Properties.)
2. Open the General tab and click the Print Test Page. The test page will be printed.

Is the Brother HL 5450DN Wireless?

About the Product Users can share the HL-5450DN with others on their network via its built-in Ethernet interface, and wirelessly print from their mobile device.

How do I reset my brother hl 5450DN?

Reset the settings to factory default

1. Power the machine off.
2. Press down the GO button and power the machine on.
3. Keep pressing GO until the all LEDs are on. The Ready LED will be off.
4. Release GO. All LEDs will be off.
5. Press GO ten times. Your machine’s printer settings will be reset.

Why won’t my Brother printer print a test page?

The most common reason a networked Brother machine may stop printing, is because the connection between the computer and the Brother machine is lost. This can occur as a result of wrong settings or configuration of the printer driver. Once you are able to print, enable your firewall again.

How do I run a test page on my Brother printer?

How do I print a Test page?

1. Turn off the printer.
2. Make sure that the front cover is closed and the power cord is plugged in.
3. Hold down Go as you turn on the power switch. Keep Go pressed down until the Back Cover, Toner, Drum and Paper LEDs light up. Release Go.
4. Press Go again. The printer will print a test page.

Is the Brother HL 5450DN a color printer?

Product Description. The HL-5450DN is a monochrome laser printer with a built-in Ethernet network interface.

How do you change the toner on a Brother HL 5450DN?

Unpack the new toner cartridge. Hold the cartridge level with both hands and gently shake it from side to side several times to spread the toner evenly inside the cartridge. Pull off the protective cover. Put the new toner cartridge firmly into the drum unit until you hear it lock into place.

How do you reset the drum counter on a Brother HL 5450DN?

Reset the drum counter for Brother HL-5450/5470/6180 series…

1. For the models with LCD: Hold down Go until the Drum Clear message is displayed on LCD, then release Go.
2. For the models without LCD: Press and hold down Go for about 4 seconds until all the LEDs light up. Once all six LEDs are lit, release Go.

How do I run a print test on a Brother printer?

How do I check the quality of my Brother printer?

Check the Print Quality

1. Press [Ink]>[Improve Print Quality]>[Check Print Quality].
2. Press [Start].
3. Check the quality of the four color blocks on the sheet.
4. The Touchscreen asks about the print quality.
5. The Touchscreen asks you to check the print quality of each color.
6. Do one of the following: