How do you attach a nail plate?
How to Install Nail Plates to Protect Electrical Wiring
- Drill wiring holes through the wall studs. Run the wiring to outlet, switch, and junction boxes.
- Hold a nail plate in place on the drywall side of the wall stud, over the wiring hole.
- Repeat on the other side of the stud in the same location.
How do you attach nail plates to trusses?
How to Install a Truss Plate
- Arrange the truss members on the ground.
- Lay the plywood truss plates at the connection of each truss.
- Hammer the truss plates into place with five 6 d nails on each connecting member.
- Repeat the procedure for all connections on one side of the truss.
What is a gang nail plate?
A truss connector plate, or gang plate, is a kind of tie. Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are also known as stud ties, metal connector plates, mending plates, or nail plates.
Are nail plates required?
It only applies to cables passing through a hole in the member. It sounds like in your case, the cables are run on top of the purlins, so technically, you do not need nail plates there. The thing is, the steel siding does not get attached with puny, short drywall screws, but rather long ones probably.
What is a connector plate?
Connector plates have integral teeth, are manufactured to various sizes and thicknesses, and are designed to laterally transmit loads in wood. They are also known as nail plates, truss plates, metal connector plates, and foundation wall angles. These connector plates are used mainly in truss repairs and construction.
Do you put gussets on both sides of a truss?
Most trusses call for a few different shaped gussets. Repeat step one and two for each gusset shape you will be cutting. Remember that you will need two complete sets of gussets for each truss you build, as they have to be mounted to both sides of the rafter.
What are connector plates?
Connector plates have integral teeth, are manufactured to various sizes and thicknesses, and are designed to laterally transmit loads in wood. They are also known as nail plates, truss plates, metal connector plates, and foundation wall angles.
When should nail plates be used?
A nail protection plate helps prevent nails from piercing pipes and electrical lines after the plaster walls are installed and the finish trim is being applied. Nail Protection Plates are typically installed over utilities that pass through framing members.
Where are Gang-Nail trusses made?
Gang-Nail Trusses is a Canadian manufacturer of floor and roof trusses located in the town of Pilot Butte, Saskatchewan (7 miles East of Regina). We have been fabricating trusses in the Regina area since 1976.
How are knuckle nail plates installed?
Knuckle Nailplates are installed simply by hammering on the knuckles of all nails in each plate. It is recommended that the hammer be parallel to the length of the nails (see diagram below) to ensure full penetration of the nails. Hammer Parallel to Nails A natural arc or dovetail effect is created by the nails as they penetrate into the timber.
What is a gang plate for trusses?
A truss connector plate, or gang plate, is a kind of tie. Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are produced by punching light gauge galvanized steel to create teeth on one side. Moreover, can you use mending plates for trusses? Mending plates are not intended for structural use.
How do you attach nails to a metal roof truss?
Nail through the bottom horizontal board of the truss on an angle into the top plate on each wall to hold it in place.