How do you reset the maintenance light on a 2008 Toyota?

How do you reset the maintenance light on a 2008 Toyota?

How to Reset the Maintenance Required Light?

1. Turn Your Vehicle on. Your key should be switched to the on position and look on your dashboard.
2. Turn the Vehicle Off and Press the Trip Meter Reset Button.
3. Turn the Vehicle Back on.
4. Keep the Reset Button Pressed.
5. Release the Reset Button.

How do you reset the oil light on a Toyota Corolla?

Locate and press and hold the “trip reset” button on the odometer. Hold the button until “Trip A” appears on the screen. Then, turn the key back to “Off.” Locate the “trip reset” button again and turn the key back to the “On” position.

How do you reset the maintenance required light on a 2008 Toyota Camry?

Quickly push and hold the odometer button on your dashboard, then turn your key to position two. Continue to hold the odometer button for about 10 seconds. The maintenance light should start to flash, and you may hear a beeping sound. Then the light should go out.

How do you reset the maintenance required light on a 2007 Toyota Corolla?

Turn Off Maintenance Light – Toyota Corolla Turn the key to the “ON” position, but don’t start the car. Press and hold the trip reset button near the odometer until “Trip A” appears on the central screen. Turn the key back to “OFF.” While pressing the button to reset the trip, turn the key back to the “ON” position.

How do you reset the oil light on a 2009 Toyota Matrix?

2009-2014

1. With vehicle ignition switched to ON position, make sure odometer is showing “Tripmeter A”, then turn the ignition switch to OFF position.
2. Push and hold the TRIP reset or MODE button.
3. While holding reset button, switch ignition to ON position.

How do you reset the check engine light on a 2008 Toyota Matrix?

Press and hold the car horn for about 30 seconds to drain any electricity from the vehicle’s capacitor. Wait to reconnect the battery. You’ll want to wait about 15 minutes for the error codes to be deleted and the engine light to turn off. Once that’s done, you can go ahead and re-install the car battery cables.

How do I reset the oil change on a Toyota Corolla?

How to Reset the Oil Change on a Corolla Place the Toyota Corolla key into the ignition, but do not turn the key. Ensure the odometer reading on the instrument panel is on the odometer setting (not the Trip A or Trip B settings). If necessary, press the odometer/reset button (located below the reading)…

How do I perform the Toyota Tacoma oil change reset?

Press and hold the trip odometer reset knob. Turn the ignition switch to the “on” position without starting the engine. Release the trip odometer reset knob after the odometer displays six zeros, then goes blank. Turn the ignition switch off. The oil change light will not come on the next time the Tacoma is started.

How do I perform the 2008 Toyota Tundra change oil reset?

How to Reset the Change Oil Light on a 2008 Toyota Tundra. Set the odometer display on the dash to “Trip A” by pushing the “Trip Reset” button once. The “Trip Reset” button is located at the bottom right of the speedometer window in the dashboard. Turn the ignition off. With your left hand, push the “Trip Reset” button.

How do I reset the oil light on a Toyota Yaris?

How to Reset the Oil Service Light on a Toyota Yaris Insert the ignition key and turn it to the “ON” position. Set the trip meter to the “A” setting. Turn the ignition key to the “OFF” position.