Can I use my old router as a wireless bridge?

Can I use my old router as a wireless bridge?

You can buy a dedicated wireless bridge, but if you have an old router lying around, you might be able to convert it into a wireless bridge using DD-WRT. DD-WRT is free Linux-based firmware for routers that replaces the router’s factory firmware.

How do I create a wireless bridge?

To set up bridge mode:

1. Make a note of the WiFi settings of the other router to which this router will connect.
2. Launch a web browser from a computer or mobile device that is connected to the network of the router that will run in bridge mode.
3. Enter the router user name and password.

How do I turn my router into a wireless receiver?

In order to get a router to work as a wireless bridge, it needs to be working in “client” mode. Unfortunately, most stock router firmwares won’t give you the option of turning your router into a client. As such, if your router doesn’t support this functionality, then you’ll need to flash DD-WRT before you can proceed.

What’s in the box with the Belkin N450 DB wireless dual-band router?

1 What’s in the box N450 DB Wireless Dual-Band N Router Ethernet cable (attached to router) Power supply (attached to router) Network information card (attached to router) Belkin Setup CD with User Manual Quick Setup Guide Initial setup

How do I connect my N450 DB router to my modem?

Connect Your N450 DB Router Turn off your modem by disconnecting its power supply. Some modems have a battery backup; this will need to be disconnected at this time as well. Connect your Router to your modem using the cable (already attached). Power up your modem by plugging in its power supply.

How do I Configure my Belkin wireless router as an access point?

Configuring your Belkin wireless router as an access point is useful in situations where you want to expand your network using your extra Belkin router. Before you begin: Connect your computer to the router which you will configure as an access point. Make sure that it is powered ON.

How do I reboot two Belkin routers?

Reboot both routers by unplugging their power cables and plugging them back in. Allow the units a minute or two to fully boot. Belkin: How Do I Set Up a Wireless Bridge Between Two Belkin Routers?

https://www.youtube.com/watch?v=DbaaGWKqmBQ