Can you fit dry verge to existing roof?
Fitting dry verge to old roof If you are fitting your dry verge to an existing building, you need to remove all of the old underclock and motor bedding before fixing. A timber batten can then be installed running from the eave to the ridge to provide a base for the units to fix into.
How do you fit a continuous dry verge?
Installation Procedure for Continuous Dry Verge Type S (Slate) Fascia Experts Continuous Dry Verge should be cut to the required length allowing for a plumb cut at the ridge, and approximately 150mm longer than the rafter. The horizontal flange is cut away, to allowing fitting over the felt support tray at the eaves.
What kind of mortar is used for roof tiles?
PRODUCT USE QUIKRETE Roof Tile Mortar FL-15 is designed for installing flat, low, and high-profile clay and concrete tile on roofs over granular roofing paper or other approved underlayment materials. It is approved for use in the HVHZ (High Velocity Hurricane Zone).
What is a continuous dry verge?
Continuous Dry Verge will give complete protection and continuous watertight cover to your property, against water penetration between tiles and brickwork or bargeboard at gable ends, giving a greater security to the verge.
How to fit a dry verge on a wall?
How to fit a dry verge Step 1:. Install the underlay if required, and ensure all battens extend beyond the gable wall or bargeboard by 20-40mm… Step 2:. Fix the batten end clips to the end of each batten. This will create a secure place on which you can fix the… Step 3:. Fit the eaves closure
Do I have to follow the manufacturer’s instructions to install a dry verge?
Each dry verge system may have slightly different installation processes due to the varied designs and manufacturers, therefore we’d always recommend following the manufacturer’s instructions. However, we’ve created a quick guide below, to outline the steps required to fit a dry verge.
What do you need to install a verge on a roof?
With a very simple installation process, the verge is supplied in packs of 10 units containing everything required for a neat and secure fixing, including Batten End Clips and stainless steel nails. A dry verge system that fits both the right and left hand side of the roof is also available for all other Redland interlocking concrete tiles.
What is a dry Verge and how does it work?
Dry verge systems are typically manufactured from plastic, which provides more durability, and also requires less maintenance. Additionally, plastic dry verges can provide a uniform, clean and attractive finish to your home, which will help increase the potential selling value.