How do I take the screen out of my PAX 2?

How do I take the screen out of my PAX 2?

Pax Screen Stuck Pop-out the mouthpiece and push the straw down from the mouthpiece and towards the screen. You will feel resistance when you hit the screen. Just give it a little nudge a couple of times and the bottom screen should just pop out.

How many times can you hit Pax 2?

PAX 2 delivers around 20 hits per fully loaded chamber.

Is the PAX 2 supposed to get hot?

My PAX 2 Mouthpiece feels very warm. What should I expect? Any heat that you are experiencing via the mouthpiece comes from the warm vapor you are inhaling, not the mouthpiece itself.

How do you change the screen on a PAX 3?

We found the best way to remove your old Pax screen is to push it out from the top using the supplied pipe cleaner.

1. Remove the mouth piece.
2. Insert pipe cleaner into the air hole on the top of the mouth piece and push all the way through.
3. Once you reach the end your screen should pop right out.

How do I reinsert my PAX screen?

Press firmly down in the center of the screen, so that it curves in the middle. The screen should lock right in place. After inserting, flip your PAX over and tap the sides. If the screen stays put then you’re good to go!

How often do you change PAX screen?

For the freshest tasting vapor possible, it’s recommended to replace your screen every few months, but with regular cleaning PAX oven screens can last quite awhile. Discoloration or staining may occur, but so long as vapor can still pass around the scalloped edges, it will not affect the functionality of your screens.

How long does PAX 2 take to heat up?

PAX 2 has four predetermined temperature settings: 360°F (180°C), 380°F (193°C), 400°F (204°C), and 420°F (215°C). It takes approximately 45 seconds for the device to reach 400°F from room temperature.

How do you pack a Pax 2?

Pack. The PAX 2 works best tightly packed, helping the heat spread throughout the bowl. You can use the lid to firmly tamp down the contents of the oven. Smaller loads still need to be tightly packed for best performance.

How do I turn Pax 2 on and off?

A short press in the center of the mouthpiece will turn your device on. You can also remove the mouthpiece to power on. PAX 2 heats in as little as 30-60 seconds. The LED petals will pulse purple while heating. Once the LED lights turn green, you’re good to go.

How do I Clean my Pax 2 oven screen?

To wrap up your PAX 2 cleaning session, make sure that both your mouthpiece and oven screen are completely dry. Return the oven screen to the oven by laying one end furthest from the vapor pathway and gently laying in the screen the rest of the way. Press firmly in the center with a cotton swab to secure it back into place.

What happens if Pax 2 doesn’t sense my lips?

If PAX 2 doesn’t sense your lips for 20 seconds the oven temperature will lower by a few degrees to preserve the internal temperatures of your material. This saves your material from heating while you’re not drawing from the device and ensures your next draw is always perfect.

What is the Pax screen?

The PAX screen is actually a solid plate with a screen-like pattern; no actual holes. The design allows for maximum heat transfer and channels vapor around the scalloped edges as you draw on the device. How should I insert the screen in the oven?