How do you adjust a water pressure switch on a Square D?

How do you adjust a water pressure switch on a Square D?

Turning the smaller nut and spring will adjust the upper end cut off pressure. Moving the nut in a clockwise direction will raise the upper limit of the pumps operation. Turning the nut in a counter clockwise direction will lower that overall cut off pressure. Exercise caution when adjusting this setting.

How do you adjust a Square D Pumptrol?

Models FTG and FHG have only one adjustment spring. Turn the range nut clockwise to increase the cut-in pressure and counter-clockwise to lower the cut-in pressure. Three and a half revolutions of the range nut will change both the cut-in and cut-out settings by approximately 10 psi.

How do I adjust my water pressure?

The screw is your adjuster and it can be maneuvered only by loosening the locknut. As you tighten the screw, the water pressure will become greater and as you loosen it, the water pressure will lessen, so turn the screw clockwise to increase the pressure, or turn it counterclockwise to decrease the pressure.

How do you adjust cut-in and cut out pressure?

Setting the cut-in pressure.

1. Starting from an empty tank. Start the compressor and let it run until it reaches the cut-out pressure.
2. Open a drain to slowly let some air escape.
3. Wait until the compressor starts.
4. Adjust the cut-in pressure with the big set screw.
5. Close the drain valve.

What are Square D pumptrol switches?

The Square D Pumptrol by Schneider Electric Water Pressure Switches have been providing rugged, reliable performance for over 67 years. These switches are designed to control electrically driven water pumps and air compressors.

How to set the pressure switch on Square D 9013?

Electromechanical Square D Brand 9013 For power circuits, FSG, FTG, FYG, FRG, FHG, and G When setting the pressure switch, adjust the switching point on rising pressure first and then the switching point on falling pressure. Switching point on falling pressure

What kind of switch is a 9013 pump switch?

9013 PUMPTROL®Commercial Pressure Switches Type F and 9013 Commercial Pressure Switches Type G 3 ContentsCommercial Pressure Switches Electromechanical Square D Brand 9013 Pressure Switches

What type of pumps can the Square D by Schneider Electric pressure switch?

The Square D by Schneider Electric Pressure Switch can be used with jet pumps, submersible pumps and reciprocating pumps. The switch has a 1/4 in. pressure connection. You will need Adobe® Acrobat® Reader to view PDF documents. Download a free copy from the Adobe Web site. How can we improve our product information? Provide feedback.