How does Ford Explorer 4X4 auto work?
If you are traveling in two-wheel-drive, 4X4 auto or 4X4 high, you must come to a complete stop first. You must then shift the transmission to neutral, then push the 4X4 low button. When the “4X4 LOW” light illuminates on the dashboard, your are ready to continue in 4X4 low.
How do you put a 2002 Ford Explorer in 4 wheel drive?
If you want to switch to 4wd you must come to a complete stop and shift the transmission into neutral. After that just push the 4×4 button.
Does 2002 Ford Explorer have 4 wheel drive?
The Used 2002 Ford Explorer comes with four wheel drive, and rear wheel drive. Available transmissions include: 5-speed automatic, 5-speed manual.
What is the difference between 4WD AUTO and 4WD high?
4×4 High works by the power supplied to the front and rear wheels at the same time whereas 4×4 auto automatically navigates power to all four wheels while varying the ratio between front and back axles to what’s needed. 4X4 auto can be left on at all times while 4×4 high should not be left on.
What does the auto 4WD button do?
Auto (Automatic) When set to Auto 4WD, your vehicle will automatically switch from 2WD to 4WD when needed. In 2WD mode, the vehicle will send power to either the front or rear wheels. If the system detects road conditions that require 4WD, like a slick, treacherous slope, it’ll shift automatically to 4WD.
How do you turn off the 4×4 in a 2002 Ford Explorer?
Turning off the 4×4 on Your Ford Explorer is accomplished by pressing one of the three buttons on Your dash by Your radio labeled 4×4 High, 4×4 Low, and 4×4 Auto. You need to be in neutral, and then push one of the buttons to go into, or out of, that mode.
How do I know if my Ford Explorer is all wheel drive?
Look underneath your vehicle while it is turned off for the axle shaft. The shaft simply looks like a large bar going from the front to rear axle. If you see an axle shaft running from the front to rear axles, you have an all-wheel drive vehicle.
How many cylinders does a 2002 Ford Explorer have?
6
8
2002 Ford Explorer/Number of cylinders
Can you drive in 4WD Auto all the time?
Car and Driver notes that 4WD is not meant to be used all the time. It’s only for certain road types, including rugged terrain and off-roading, as well as slippery conditions, like snow or mud. Otherwise, 4WD vehicles should be driven in two-wheel drive, according to Car and Driver.
Is Auto 4WD bad to use?
Using Auto 4wd will not hurt anything. It is there and available if the truck detects wheel slippage. But, the hubs are free, so it’s not putting extra load on your transfer case. You don’t want to use 4wd high for long distances on dry pavement.
Is it bad to drive in 4 auto?
Although not always optimal for efficiency and wear of your vehicle 4wd driveline, AUTOMATIC 4 HI can be used on any road condition without risk of damaging your vehicle. Low range is meant predominantly for off-road situations, and should not be used at speeds above 45 mph.
Where is the fuel pump located on a Ford Explorer?
wher is the fuel pump located on a ford explorer. It is located in the gas tank.
Where is the starter located in a Ford Explorer?
The starter location in a Ford Explorer depends on the model year. In most engines, however, the starter can be found under the engine block, near the transmission.
What type of SUV is a Ford Explorer?
Ford Explorer. The Ford Explorer is a range of SUVs manufactured by Ford Motor Company. Introduced in 1990 for the 1991 model year, it is currently in its fifth generation. Variants have also been marketed through the Lincoln- Mercury Division as the Mercury Mountaineer (1997-2010) and Lincoln Aviator (2003-2005).